Special order, Not Returnable

BDS Suspension 5.5 inch radius arm lift kit 2019+ Ram 3500 - Gas only

Add to cart
  • Description
  • More

BDS Suspension Lift Kit

Allow 2 to 6 weeks delivery

Important Kit Notes

  • 6.4L gas models will require exhaust modification to clear front driveshaft. Vehicle can be driven w/o front driveshaft for an exhaust shop to make necessary modifications
  • Will not fit rear air-ride equipped models
  • Will not fit chassis-cab models
  • Will not fit dually models

BDS Suspension is now shipping complete 5.5" radius arm systems for the 2019+ RAM 3500 4WD gas trucks
Designed to improve the looks and performance of your new RAM, these kits include everything necessary to correctly lift them for improved offroad capability with room for larger tires while maintaining on-road handling.

Up front these systems use a pair of (gas specific) progressive rate 5.5" coil springs to provide the extra height and smooth controlled performance in the harshest of terrains. A forged drop pitman arm is supplied to correct steering angles along with a HD bar drop bracket to re-center the front axle. A pair of sway bar drop brackets reposition the OE sway bar for optimal performance along with extended polyurethane bump stops to limit up travel and brake line brackets to allow full droop. To correct the front suspension geometry at the new height a pair of heavy duty replacement radius arms that bolt directly into the factory location. These new radius arms are massive upgrade to the factory stamped units, using tubular construction and a lower cam adjustment to dial in front end caster. Also supplied are your choice of BDS NX2 gas shocks or FOX 2.0 performance series IFP gas shocks for improved ride and performance.

At 5.5" of lift it is critical to correct the front driveline angle to maintain use of the 4WD. To do this BDS Suspension provides a heavy duty replacement transmission crossmember as well as a transfer case indexing ring to reposition the front driveline output to allow use of the factory drivelines. In the rear of the RAM 3500 kits a 5" block and u-bolt kit is used for a level-to-slightly tail-high stance while maintaing tow capacity. Finishing out the rear are a matching set of BDS NX2 gas shocks or FOX 2.0 performance series IFP gas shocks.


Tire & Wheel Combinations
37x12.50 w/20x9 and 4.5-5.625" back spacing
37x12.50 w/20x9 and 5.625 back spacing
*Trimming may be required*

Est. Installation: 8 hours
Difficulty Level (easy 1 - 5 complicated): 3