Aftermarket steering stabilizer required. Factory drag link mount taper will be flipped when dropped pitman arm is installed. Order proper Zone stabilizer listed in accessories if replacement is needed.
If truck is equipped with rear brake proportioning valve, proportioning valve relocation bracket kit (D5509) is required.
Will not fit models built before February 9, 1994 due to track bar stud size.
Factory block is replaced with 5" block and add-a-leaf combo to obtain a level stance.
These models came equipped from the factory with two different factory sway bar link setups. For models that have the factory front sway bar links mounted ABOVE the axle bracket, optional sway bar link kit D5501 is required. For models that have the factory front sway bar links mounted BELOW the axle bracket, no additional sway bar link kit is required.
If equipped with rear top mounted overload springs 4 of u-bolt part # UBT4050 may be required.
If vehicle is equipped with a factory rear sway bar, optional rear sway bar link kit # D5508 is recommended.
Models equipped with a 2 piece rear driveshaft and carrier bearing will require optional carrier bearing drop kit # D5505